Features

After removing the 3 screws the main drive bay cage slides out like so:

Again (like the 3rd time so far) you can see the holes drilled out on the side to improve cooling potential.

Fan Mounts; as you have seen above, there are two 120mm fan mounts on the back, in case you have already forgotten, maybe this pick will stir your pot of grey goo:

As you may notice the lower 120mm fan mount is obstructed. I find this to be a rather nice detail, LiteON so kindly included a cover for this mount, incase you only have 2 120mm fans at your disposal. Maybe the folks over at LiteON understand the need to strictly control air flow within a case to properly cool it... just maybe... ;)

To remove this cover you need to push out the pins, use your finger, it won’t hurt

Then grab a screwdriver and pop it out,

The other place for a 120mm fan (even though you can use an even larger one) is at the bottom front of the case:

The 120mm fan is mounted in a fan cage, removing it is pretty easy, just unclip it and she’ll slide out nice and easy, just like so (the fan cage folks, stay with me):

Here’s pic of it taken out:

>> Features Part 5/Conclusion